Walnut - Buggy

What you need for one buggy:

• one half of a walnut
• a little bit of a cardboard box for the 4 wheels and the bottom of the buggy
• two toothpicks as wheel axles
  
• a cutter
• a pencil
  
• some glue
  
• one or two feathers as sunshade
• a pipe cleaner for the handle
  

• a pipe cleaner in a colour you like

You start the buggy with cracking the walnut in two halfs.

Then you draw 4 tiny wheels on the cardboard not bigger than 1 to 1,5 cm in diameter and cut them out.

You perforate the wheels in the middle using the toothpicks. 

Then you cut out a rectangle 2 cm x 3,5 cm where you can fix the walnut using the glue.

Then you have to put the 2 toothpicks through the little tubes of the cardboard one quite in front, the other one at the end. Then you can put on the 4 wheels to fix everything.

In case you like a sunshade you can now fix the feather in front of the buggy.

Now bend the pipe cleaner to  get the handle of the buggy and fold the ends into the walnut.

Then you take the second pipe cleaner and form a little doll out of it and put it onto the handle-end in the nut.